Skip to main content

NetApp Stage KB

E-Series Impending drive failure detected by drive - AutoSupport Message

  1. Last updated
  2. Save as PDF

Views:
6
Visibility:
Public
Votes:
0
Category:
not set
Specialty:
not set
Last Updated:

Applies to

NetApp StorageGRID

Event Summary

SANtricity reports a impending drive failure. This means that the drive could/should fail soon. The data on the drive is still available to the E-Series system.

Validate

  1. Login to SANtricity Storage Manager or SANtricity System Manager
  2. Verify from the Hardware page if the disk shows as impending failure
  3. The event log should report one or more of the following errors:
    • Event type: 2285 Description: Impending drive failure detected by drive
    • Event type:101f Description: Summary of impending drive failure detected by controller
    • Event type: 1023 Description: Drive copy triggered by a controller detected impending drive failure

Resolution

  1. Monitor the system and check within several hours drive should fail.
    • If AutoSupport is enabled, this event should create a technical support case once the drive is failed
  2. Replace the drive once its failed.
  3. It might be required to manually fail the drive if the data copy is not progressing. Only perform this action when instructed by NetApp Technical Support.

Additional Information

Diagnosing an impending drive failure on E-Series platforms

 

NetApp provides no representations or warranties regarding the accuracy or reliability or serviceability of any information or recommendations provided in this publication or with respect to any results that may be obtained by the use of the information or observance of any recommendations provided herein. The information in this document is distributed AS IS and the use of this information or the implementation of any recommendations or techniques herein is a customer's responsibility and depends on the customer's ability to evaluate and integrate them into the customer's operational environment. This document and the information contained herein may be used solely in connection with the NetApp products discussed in this document.