Skip to main content
NetApp Stage KB

Storage Switch Add command fails on Brocade switch

Views:
Visibility:
Public
Votes:
0
Category:
metrocluster
Specialty:
MetroCluster
Last Updated:

Applies to

  • MetroCluster
  • Brocade storage switch

Issue

The storage switch add command fails on the NetApp cluster when trying to add a Brocade switch:

CLUSTER01::*> storage switch add -address 192.168.0.24 -snmp-version SNMPv3 -snmp-community-or-username snmpv3user


Error: command failed: Internal error. Failed to add switch for monitoring on node "NODE01" in cluster "CLUSTER01". Reason: Failed to check if device located at "192.168.0.24" is from supported vendor. For further assistance, contact technical support.

 

Sign in to view the entire content of this KB article.

New to NetApp?

Learn more about our award-winning Support

NetApp provides no representations or warranties regarding the accuracy or reliability or serviceability of any information or recommendations provided in this publication or with respect to any results that may be obtained by the use of the information or observance of any recommendations provided herein. The information in this document is distributed AS IS and the use of this information or the implementation of any recommendations or techniques herein is a customer's responsibility and depends on the customer's ability to evaluate and integrate them into the customer's operational environment. This document and the information contained herein may be used solely in connection with the NetApp products discussed in this document.
ac026257-f682-419b-82c2-36c88992abdb

 

  • Was this article helpful?