Skip to main content
NetApp Stage KB

ATTO FibreBridges show different active configurations

Views:
1
Visibility:
Public
Votes:
0
Category:
metrocluster
Specialty:
MetroCluster
Last Updated:

 

Applies to

  • ATTO 6500N FibreBridge
  • ATTO 7500N FibreBridge

Issue

In the Info section of the ATTO FibreBridge Active Configuration is listed as either ATTO or NetApp(_v2).


Ready.
Info

Device Status         = Good
Device                = "FibreBridge 6500N"
...
MP2 IP Address        = 0.0.0.0
MP2 IP Subnet Mask    = 255.255.255.0
MP2 IP Gateway        = 10.64.25.1
MP2 IP DHCP           = disabled
Active Configuration  = ATTO

Ready.

 

Sign in to view the entire content of this KB article.

New to NetApp?

Learn more about our award-winning Support

NetApp provides no representations or warranties regarding the accuracy or reliability or serviceability of any information or recommendations provided in this publication or with respect to any results that may be obtained by the use of the information or observance of any recommendations provided herein. The information in this document is distributed AS IS and the use of this information or the implementation of any recommendations or techniques herein is a customer's responsibility and depends on the customer's ability to evaluate and integrate them into the customer's operational environment. This document and the information contained herein may be used solely in connection with the NetApp products discussed in this document.