Skip to main content
NetApp Stage KB

MetroCluster Aggregate Plex in Failed State After Site Power Outage

  1. Last updated
  2. Save as PDF

Views:
Visibility:
Public
Votes:
0
Category:
metrocluster
Specialty:
metrocluster
Last Updated:

Applies to

  • ONTAP 9
  • MetroCluster (Fabric-Attached, 2-node configuration)

Issue

After a site power outage, the following issues were observed:
  • MetroCluster switched over to the partner site, node rebooted.
  • Two ATTO bridges on the site rebooted at the same time.
  • Aggregates online, but two plexes are in failed state.
  • All disk paths (4 per disk) were visible after bridges and switches returned online, but plexes remained failed.

Sign in to view the entire content of this KB article.

New to NetApp?

Learn more about our award-winning Support

NetApp provides no representations or warranties regarding the accuracy or reliability or serviceability of any information or recommendations provided in this publication or with respect to any results that may be obtained by the use of the information or observance of any recommendations provided herein. The information in this document is distributed AS IS and the use of this information or the implementation of any recommendations or techniques herein is a customer's responsibility and depends on the customer's ability to evaluate and integrate them into the customer's operational environment. This document and the information contained herein may be used solely in connection with the NetApp products discussed in this document.