Skip to main content
NetApp Stage KB

Management IP Address is not displayed for ATTO FibreBridge after Upgrade to 9.16.1P9

  1. Last updated
  2. Save as PDF

Views:
Visibility:
Public
Votes:
0
Category:
aff-series
Specialty:
metrocluster
Last Updated:

Applies to

  • ONTAP 9.16.x
  • ATTO FibreBridge 7600N

Issue

  • After upgrading ONTAP and ATTO FibreBridge firmware, the management IP address for ATTO FibreBridge 7600N bridges is not displayed in ONTAP CLI output.

Example log output:

ddxxx001::> system bridge show -fields name,address
name                  address
--------------------- --------
ATTO_2xxx0            0.0.0.0
ATTO_2xxx0            0.0.0.0
ATTO_2xxx0            0.0.0.0
... (other bridges)

  • The "system bridge show" command shows the management IP as 0.0.0.0. 
  • The bridges remain accessible via HTTP/HTTPS and ONTAP "storage bridge run-cli" commands.
  • All health checks pass, and there is no impact to storage access or IO.

storagebridgerun-cli -name <bridge_name> -command infostoragebridgerun-cli -name <bridge_name> -command infostoragebridgerun-cli -name <bridge_name> -command infostoragebridgerun-cli -name <bridge_name> -command info

Sign in to view the entire content of this KB article.

New to NetApp?

Learn more about our award-winning Support

NetApp provides no representations or warranties regarding the accuracy or reliability or serviceability of any information or recommendations provided in this publication or with respect to any results that may be obtained by the use of the information or observance of any recommendations provided herein. The information in this document is distributed AS IS and the use of this information or the implementation of any recommendations or techniques herein is a customer's responsibility and depends on the customer's ability to evaluate and integrate them into the customer's operational environment. This document and the information contained herein may be used solely in connection with the NetApp products discussed in this document.