Skip to main content
NetApp Stage KB

Attached shelf not listed in sysconfig -a output

  1. Last updated
  2. Save as PDF

Views:
Visibility:
Public
Votes:
0
Category:
metrocluster
Specialty:
metrocluster
Last Updated:

Applies to

  • MetroCluster IP
  • ONTAP 9

Issue

  • No corresponding shelf information for a disk stack is shown in output of sysconfig -a for SAS ports on both local nodes of a DR group:
Example:
ClusterA::*> system node run -node ClusterA-01 -command "sysconfig -a"
    ...
    slot 10: SAS Host Adapter 10a (PMC-Sierra PM8072 rev. C, SAS, <UP>)
    ...
        30.0 : NETAPP   X357_SLBPE3T8ATE NA51 3662.5GB 520B/sect (XXXXXXXX)
        ...
        31.0 : NETAPP   X357_SLBPE3T8ATE NA51 3662.5GB 520B/sect (XXXXXXXX)
        ...
        Shelf 30: DS224-12  Firmware rev. IOM12B A: 0141  IOM12B B: 0141 <-- Missing from output
        Shelf 31: DS224-12  Firmware rev. IOM12B A: 0141  IOM12B B: 0141
  • The correct number of disks visible

Sign in to view the entire content of this KB article.

New to NetApp?

Learn more about our award-winning Support

NetApp provides no representations or warranties regarding the accuracy or reliability or serviceability of any information or recommendations provided in this publication or with respect to any results that may be obtained by the use of the information or observance of any recommendations provided herein. The information in this document is distributed AS IS and the use of this information or the implementation of any recommendations or techniques herein is a customer's responsibility and depends on the customer's ability to evaluate and integrate them into the customer's operational environment. This document and the information contained herein may be used solely in connection with the NetApp products discussed in this document.