Skip to main content
NetApp Knowledge Base site will be down for 3 hours between Oct 26, 23:59 PST and Oct 27, 02:59 PST, for system maintenance and infrastructure update.
NetApp Stage KB

What does vnvram.dma.long.wait signal in ONTAP Select?

  1. Last updated
  2. Save as PDF
Views:
1
Visibility:
Public
Votes:
0
Category:
ontap-select
Specialty:
cloud
Last Updated:

 

​

Applies to

  • NetApp ONTAP Select
  • EMS

Answer

This message occurs when a vNVRAM flush operation on an ONTAP-v system is taking too much time. This can indicate back-end storage issues or an internal error. The system might also reboot.

Corrective Action: If the problem persists, check for back-end storage issues with the system disk.

Additional Information

NetApp provides no representations or warranties regarding the accuracy or reliability or serviceability of any information or recommendations provided in this publication or with respect to any results that may be obtained by the use of the information or observance of any recommendations provided herein. The information in this document is distributed AS IS and the use of this information or the implementation of any recommendations or techniques herein is a customer's responsibility and depends on the customer's ability to evaluate and integrate them into the customer's operational environment. This document and the information contained herein may be used solely in connection with the NetApp products discussed in this document.