Skip to main content
NetApp Stage KB

Error: command failed: Failed to assign disks after MetroCluster IP installation

Views:
1
Visibility:
Public
Votes:
0
Category:
metrocluster
Specialty:
metrocluster
Last Updated:

 

Applies to

  • MetroCluster IP
  • ONTAP 9
  • One fully populated DS224-12 shelf and one partial populated DS224-12 shelf per site
  • Advanced Disk Partitioning (ADP)

Issue

After MetroCluster IP installation not able to assign disks the following is reported:
 
Error: command failed: Failed to assign disks. Reason: Cannot assign "0m.i0.0LX" from this node. Try the command again on node "node2" .
 

 

 

Sign in to view the entire content of this KB article.

New to NetApp?

Learn more about our award-winning Support

NetApp provides no representations or warranties regarding the accuracy or reliability or serviceability of any information or recommendations provided in this publication or with respect to any results that may be obtained by the use of the information or observance of any recommendations provided herein. The information in this document is distributed AS IS and the use of this information or the implementation of any recommendations or techniques herein is a customer's responsibility and depends on the customer's ability to evaluate and integrate them into the customer's operational environment. This document and the information contained herein may be used solely in connection with the NetApp products discussed in this document.
b096c2c7-d135-4371-a3a2-ba496f9e02c4