Skip to main content
NetApp Knowledge Base site will be down for 3 hours between Oct 26, 23:59 PST and Oct 27, 02:59 PST, for system maintenance and infrastructure update.
NetApp Stage KB

CONTAP-95670: Flexgroup workload sensing information is set to default after node reboot

  1. Last updated
  2. Save as PDF
Views:
Visibility:
Public
Votes:
0
Category:
ontap-9
Specialty:
CORE
Last Updated:

 

Issue

  • Upon a reboot of a node containing one or more flexgroup member volumes,
the workload sensing information is set back to the default mixed workload 
value. 

  • This numeric workload value is used to help better balance new file
placement across flexgroup member volumes.  
- If a configuration is using   a workload value that differs from the 

default, performance degradation may occur until the workload value is 
properly calculated again on the rebooted node. 

  • This calculation happens automatically over time but may take hours to
be arrive at the correct value.

Sign in to view the entire content of this KB article.

New to NetApp?

Learn more about our award-winning Support

NetApp provides no representations or warranties regarding the accuracy or reliability or serviceability of any information or recommendations provided in this publication or with respect to any results that may be obtained by the use of the information or observance of any recommendations provided herein. The information in this document is distributed AS IS and the use of this information or the implementation of any recommendations or techniques herein is a customer's responsibility and depends on the customer's ability to evaluate and integrate them into the customer's operational environment. This document and the information contained herein may be used solely in connection with the NetApp products discussed in this document.